Dielectric testing explained

~ Electrical testing for an informed motor maintenance strategy ~

The insulation system of a motor prevents winding faults, but time, usage, moisture and other contaminants will inevitably cause insulation to deteriorate. Here Mark Convery, EMS Sales Representative at electromechanical specialist Houghton International, explains how dielectric testing can detect potential threats to a motor’s insulation system.

Around 30 per cent of electric motor failures are a result of electrical insulation breakdown, the second biggest cause of failure after bearing issues. It is therefore important to identify and predict early signs of insulation degradation for a clear picture of motor health, reducing the risk of unplanned downtime and catastrophic failure.

The electrical testing regime detailed in this article can find early indications of insulation weakness and faults in windings, between phases or coils, and in ground wall insulation. It can also detect problems with connections such as feed cable insulation weakness, motor imbalances, and open or high resistance.

At Houghton International, we begin a testing routine by checking the balance between the motor’s phases using a phase resistance test, then compare the reading for each phase to identify any anomalies. High resistance in a phase may be a sign of bad electrical joints or breakage within the coil or copper.

In order to check suitability to carry out high voltage testing, we then test Insulation Resistance (IR) and Polarisation Index (PI). These two tests provide a good indicator of the strength of the external (coil to earth) insulation of the windings. The IR reading is taken after applying the test voltage for one minute. A second reading is taken at ten minutes then divided by the first reading to calculate the PI. We would consider a PI of below two a fail. This may be a sign of a fault in the coil to earth insulation or the presence of moisture or contamination, requiring further investigation.

If the IR and PI results are satisfactory, we perform a High Potential test. Tests carried out at operating voltage may not detect smaller instances of insulation deterioration, so the High Potential test uses a higher voltage to stress insulation and detect these smaller dielectric breakdowns.

Insulation breakdown may not only occur in the external insulation, but also between turns — the individual strands of copper — within the motor windings. All coils should be nearly identical, so surge test readings from a coil or phase can be compared to identify indications of breakdowns in turn to turn insulation, dry joints or incorrect winding connections.

High voltage motors can exhibit high levels of partial discharge (PD), where localised corona discharge causes deterioration, eventually leading to insulation breakdown. This isn’t detected by standard diagnostic tests, so it is possible for a motor to appear healthy despite high levels of corona discharge. PD testing identifies these localised weaknesses and aged points of the insulation.

Electrical testing can be carried out in situ, making the process relatively quick and easy with minimal disruption. It can be carried out as a one-off assessment, but we recommended testing at regular intervals to provide a trending measure of dielectric integrity and build a more complete picture of machine health.

This is why results require interpretation, and experienced electric motor repair engineers can draw on their knowledge of a wide range of machinery to interpret tests and provide recommendations on required maintenance and repairs.

The most advanced equipment on the market is only as good as those who operate it, so it is essential to understand what you are looking for to fully benefit from the insights of electrical testing. However, with the right knowledge and equipment, it provides a valuable picture of motor health to inform operational, maintenance and capex decisions.

Automation Update